Storing your Morphy Richards MRX Complete Pro Wet & Dry Hard Floor Cleaner (model 740002) clean, dry and upright helps prevent unpleasant smells, residue and water marks between uses.
Follow this routine after each cleaning session.
1. Finish cleaning and switch off
Switch the cleaner off, return the handle to the upright park position and place it on its storage base.
Do not leave the roller running while the cleaner is stationary, as this could damage the floor.
If you are using the self-clean function, complete the cycle before preparing the cleaner for storage. See How to use the self-clean function.
2. Empty both water tanks
Switch the cleaner off and disconnect it from the charger before removing components.
- Empty and rinse the dirty water tank, including its lid.
- Remove any dirt or deposits and check that the float moves freely.
- Empty leftover water or cleaning solution from the clean water tank and rinse it with clean water.
- Wipe the outside of both tanks dry.
Avoid leaving dirty water or mixed cleaning solution in the tanks between uses.
3. Clean the roller, cover and filters
Remove hair, threads and debris from the roller and its compartment. Wash the removed roller and cover as directed in the user manual.
Check the filters and clean them as needed.
For full instructions, see How to clean the roller, tanks and filters.
4. Allow removable parts to dry
Allow the sponge filter to dry fully before refitting. Let the roller dry before refitting when the cleaner will not be used immediately.
Place cleaned components in a well-ventilated area where they can dry naturally.
- Do not enclose a damp roller beneath its cover for storage.
- Do not put components on radiators or use direct heat to speed up drying.
- Keep drying parts away from children and pets.
Once dry, reassemble the cleaner so it is ready for its next use.
5. Clean and dry the storage base
Wipe away water and residue from the base. Check that the floor underneath it is also dry.
Return the cleaner to the base once the base is clean and dry.
6. Choose a suitable storage location
Store the cleaner:
- Upright in the park position on its storage base.
- In a dry indoor location, away from direct sunlight and moisture.
- Away from heat sources and areas exposed to freezing conditions.
- Where it will not be knocked over or obstruct a walkway.
Avoid laying the cleaner on its side, particularly while there is water in either tank.
7. Charging after use
If the battery needs charging, use the charger supplied with the appliance and follow the charging instructions in the user manual.
Make sure the cleaner’s exterior, charging connection and your hands are dry before connecting the charger. Position the cable so it cannot be pulled, trapped or tripped over.
If the cleaner has become unusually hot or cut out during use, allow it to cool and follow My floor cleaner keeps stopping or cutting out before charging or using it again.
Storing the cleaner for a longer period
Before leaving the cleaner unused for an extended period:
- Empty and clean both tanks.
- Clean the roller, cover and filters.
- Allow all cleaned components to dry thoroughly.
- Reassemble and store the cleaner upright on its base.
- Disconnect the charger from the appliance and wall socket.
When you next use it, inspect the components, check the battery charge and refill the clean water tank with fresh water and correctly measured solution if required.
Why does my cleaner smell after storage?
Dirty water, trapped debris or parts stored while damp can develop stale or musty smells.
If this happens, follow My floor cleaner smells unpleasant and thoroughly clean and dry the removable components before storing it again.
Why is there water beneath the cleaner?
Check that both tanks have been emptied, the storage base is dry and all components are securely fitted.
If water continues to escape after these checks, see My floor cleaner is leaking water or contact our Customer Support team.
Need further help?
Contact our Customer Support team if you need advice about storage, charging or a component that will not refit securely.
Please include your model number, purchase details and photographs of anything you need help with.